The PPC5 replacement cell is compatible with all Pool Pilot Total Control, Pool Pilot Digital, and Soft Touch chlorine generators. The PPC5 salt cell is the factory original replacement cell model designed to easily drop in place and allow you to replace your old PPC5 cell in minutes. This cell is made to meet or exceed original factory specs and has 100% guaranteed compatibility.
Replacing the Autopilot PPC5 cell will allow your salt chlorine generator to begin chlorinating again if your old PPC5 salt cell has been depleted. The PPC5 cell sanitizes your swimming pool in an eco-friendly and cost-efficient way, and also helps provide a luxurious swimming experience without the eye irritation and dry skin.
Important: Autopilot recommends that the cell connector cord be replaced when the salt cell is replaced, in order to ensure warranty coverage. See related products below.
Sizing:
When replacing your Autopilot salt cell, take this opportunity to make sure it is sized correctly. Sizing your salt cell properly is key to making sure you will not need to supplement with additional chlorine or shock your pool, and also extends the lifespan of your cell.The industry recommends using a salt cell with a max capacity of 1.5-2 times the actual size of your pool (more is better). The PPC-5 is manufacturer rated for a maximum capacity of 80,000 gallons.
Compatibility:
This replacement salt cell for the Autopilot Pool Pilot Digital is 100% compatible with original systems (no software/firmware issues). The PPC-5 cell has the same length, threading, and cable connection for direct replacement. This 15-blade salt cell is the replacement for older systems previously named Autopilot CC-15, CC15-MF, and CC15-FF.
Autopilot Cell Compatibility Chart:
Current Cell | PPC1 | PPC2 | PPC3 | PPC4 | PPC5 |
Old Cell | AP-150 RC-5 SC-36 RC-35/22 | RC-28 | AP-250 RC-7 SC-48 RC-42 | SC-60 RC-52 | AP-500 RC-15 CC-15 |
To get the most life out of your salt cell and to keep your pool running without unexpected interruptions, make sure it is sized correctly, maintain correct water balance, and be sure and inspect your cell at least every 3 months for leaks, debris, and calcium scale. Be sure to follow instructions in the product manual and clean the cell as often as the system indicates.
General FAQ
If your salt cell needs to be replaced, you probably have a problem with low chlorine, but if your chlorine level is a problem then the cell is only one of several possible issues, notably including excessive chlorine demand. Essentially, you have either a system problem or a water problem.
System problems will generally reveal themselves with error messages or warning lights on the control module. The typical indications of the cell needing replacement will be one or both of the following: Low Salt warnings that are present with correct salinity and Check/Clean Cell warnings that display when the cell is verifiably clean.
If you are referring to buying the same brand, there’s no question that the original OEM salt cell is exactly what your system was designed to use. However, commonly there are aftermarket replacement cells available which fit into place and operate quite satisfactorily. It is your prerogative to employ one of these aftermarket replacements if you are satisfied with the specifications, price warranty, and reported compatibility.
If you were asking about buying the same capacity cell, then OEM or aftermarket alike, you need to first determine whether your control or power module can accommodate a different size. Assuming you can change sizes, a larger cell is virtually always a good choice. However, in downsizing, make sure the smaller cell is still sufficiently large to maintain 1.5-2 times sizing of the cell relative to the pool’s volume.
There are no reviews yet
|
Chlorine Output:
|
2.5 lbs/day
|
|
Manufacturer Warranty:
|
2 Year Limited
|
|
Manufacturer Max Capacity:
|
80,000 gallons
|
|
Salinity Range:
|
2500-3500 ppm
|
|
Number of Titanium Blades:
|
15
|
|
Flow Switch Included:
|
No
|
|
O-Rings Included:
|
No
|
|
Unions Included:
|
No (Does include female collars)
|
|
Unions Size:
|
2"
|
|
Clear Cell:
|
Yes
|
|
Self-Cleaning:
|
Yes, Reverse Polarity
|
|
Cable Connection Type:
|
2 Pin
|
|
Weight:
|
2.2 lbs
|
|
Dimensions:
|
12" x 6" x 6"
|
Warranty Penalty for Self-Install:
|
No
|
|
Weather / UV-Resistance:
|
Designed for Outdoor Installation and Operation
|
The Autopilot PPC5 Electrolytic Cell contains built-in titanium electrodes with 15 plates and detachable power supply cord (Note: mfg. recommends cord replacement when replacing cell). The salt cell has threaded connections on the inlet and outlet, which allow quick access for service or replacement
2-Year Limited Warranty for residential use. All warranties offered are provided by the relative manufacturer and are limited to the terms they provide. See manufacturer's documentation for a full description of warranty terms and conditions.
